Toll Free: 1-800-783-1553

Ohm FRS-11

Specifications
Production Period
1980's
Nationally Advertised Price
$1100 per pair
Amplifiers Recommended
30 - 150W
Impedance (typical)
Frequency Response
37 - 20,000 Hz (+/-3dB)
Sensitivity @2.8 Volts
90 dB
Recommended Room Sizes
960 - 2000 cu.ft.
Purchase Options Price Order
Low Repair
If there is very little sound and it is scratchy, buzzy, or it rattles in the low frequency range, then a low repair is necessary. We must receive both speakers from you so that we can match them both to the good one.
$150
High Repair

When the system is very dull sounding but most of the sound is acceptable, it usually indicates that a high repair is necessary. Sometimes this is only noticed when one speaker is compared to another. We must receive both of your drivers so that we can match them both to the good one.

$75
Metal Can
The metal can is the protective cover enclosing the driver. This should not be removed except at the Ohm factory. If repairs are attempted, the final repair cost will be higher to fix whatever additional damage is done. However, a small cosmetic dent in the area opposite the wires will have no affect on the sound. These are only sold and installed at the factory after the drivers have been tested and found to be working properly.
$30
Grill

The grill is the cloth and frame used to cosmetically conceal the drivers without affecting the sound. Ohm now uses black grills in almost all cases. In the past, brown and brown/black mixes were used. Now they are all black. The latest style uses wood and perforated metal like the thousand series. The new ones also have no seams. They are much nicer looking than the originals.

$140 4
Replace Total Driver

The total driver is the perforated metal can including all its internal parts. This option is most often used to replace lost drivers. We still need to get the other one back to make sure they are properly matched.

$595
Upgrade to SFRS-11.3000 (pair)

This upgrade exchanges the complete driver and input board, plus adds a new vent adapter. You benefit with deeper bass, higher output (about 10 dB on peaks) and extended highs with wider dispersion. The voices are more natural and the micro-dynamics more distinct. These get the drivers from the $4000 Walsh 3000. This is a 4-generation step. Each generation made an audible improvement — four generations makes a major improvement.

$2,000 1,4
Repair/Replace Metal Can

The metal can is the protective cover enclosing the driver. This should not be removed except at the Ohm factory. If third-party repairs are attempted, the final repair cost will be higher to fix whatever additional damage is done. However, a small cosmetic dent in the area opposite the wires will have no effect on the sound. These are sold and installed only at the factory after the drivers have been tested and found to be working properly.

$30
(1) With the return of the original part for recycling within 60 days.
(2) With the return of the original part for recycling before the shipment of the new part.
(3) Recycled, repaired and tested.
(4) Per pair.

The FRS-11 is a 43” tall square tower with each corner cut about 2”. One of the cut corners displays the Ohm logo near the top, just below the grill. The FRS-11 is a true Walsh speaker designed for small to medium sized rooms. They create a precise stereo image from a very wide Sweet-Sweep. We call the effect Full Room Stereo and we named it after this benefit.

To achieve Full Room Stereo the speakers should be set up six to eight feet apart with the Ohm logos pointed so the crossfire is in front of the listening area. Nothing taller than the cabinets should be placed between them (at least half of the speakers should be totally clear).

The speaker can be upgraded with Walsh 3000 driver and a vent adapter to tune the cabinet lower for deeper bass. Installation requires a screwdriver and takes only 10 minutes to install.

Note: Most Ohm upgrades require no specialized knowledge and are easily completed completed by any person. It takes less time to install your own upgrade than it does to package and return ship your speakers to the factory, therefore, we recommend you save time and money by doing this yourself. We ship the upgrade to your door with clear, easy instructions. If for any reason you prefer to have the factory complete your upgrade installation, we will be happy to do this for free, however, you will be responsible for shipping and handling costs each way.

Ohm allows up to $1395 for the return of a complete undamaged pair of Ohm FRS-11s toward 25% of the purchase price of new Ohm speakers.

back to top